Notifications
Clear all

Software preference

23 Posts
12 Users
0 Reactions
12.2 K Views
Donny M. Carter
Posts: 1008
Topic starter
(@donny-m-carter)
Noble Member
Joined: 16 years ago
[#30269]

CAD/ Design Software preference

What CAD software do you design in? What do you like about and dislike about it? Thanks for any comments!

Donny


22 Replies
Posts: 283
(@gigogig)
Reputable Member
Joined: 16 years ago

Re: CAD/ Design Software preference

nothing better than http://brlcad.org/ for the price, but its a hard learning curv


Reply
Donny M. Carter
Posts: 1008
Topic starter
(@donny-m-carter)
Noble Member
Joined: 16 years ago

Re: CAD/ Design Software preference

gigogig wrote:nothing better than http://brlcad.org/ for the price, but its a hard learning curv

Thanks Bobby, I'll check it out!


Reply
dowis
Posts: 161
(@dowis)
Estimable Member
Joined: 18 years ago

Re: CAD/ Design Software preference

I prefer Solidworks. Nice intuitive interface and solid platform. I've also used Rhino in the past.

It really depends on what you're modeling. Simple toying around with smaller scale single component stuff you could use one of several free software packages.


Reply
Donny M. Carter
Posts: 1008
Topic starter
(@donny-m-carter)
Noble Member
Joined: 16 years ago

Re: CAD/ Design Software preference

dowis wrote:I prefer Solidworks. Nice intuitive interface and solid platform. I've also used Rhino in the past.

It really depends on what you're modeling. Simple toying around with smaller scale single component stuff you could use one of several free software packages.

Thanks! I've been playing with sketch up a little. Just wanting to get a feel for 3D software. I'm thinking about ordering a Replicator2.


Reply
Page 1 / 5
Share: