Kulp K32A-B Questions

[jbair]

Hi, I'm back again. I have built this controller box and am ready to put power to the thing. Because I don't want to let any smoke out of the controller I have a few questions.

My controller is a Kulp K32A-B. There are no instructions included with it so I downloaded the K16 manual. Not much help with the wiring.

1. In the K16 manual it says that I need to set a jumper for the power being used (12-5). I can not find the jumper. Have they eliminated the need to do that?
2. I thought I read somewhere that each of the four power termination ports can be either 12VDC or 5VDC and a mix of. True?
3. Which of the power ports runs the board and BBB?

Thanks for any help that you can give me.

 

[mrGrumpy]

See attached pic
1. Power port voltage, bottom right, is set by Input Voltage Select
2. Yes. Each corner has a voltage input terminal feeding its 8 ports.
3. Bottom right (my pic) is board power source, and MUST be correctly set at Input Voltage Select

 

[jbair]

See attached pic
1. Power port voltage, bottom right, is set by Input Voltage Select
2. Yes. Each corner has a voltage input terminal feeding its 8 ports.
3. Bottom right (my pic) is board power source, and MUST be correctly set at Input Voltage Select

Thanks for the info. I found that the newer version is plug and play. There is no voltage select. That happens to be what I have. I wish that they sent some kind of information with the order. Thanks again.