Kev7274 wrote:Did you have to snap them apart? I think I know what you are talking about, but not sure. They were small and you soldered the wires to ...
Well maybe not. I’ve looked at these and it does ring a bell. However the units I have were just the PCB board and you had to solder it all yourself. ...
F-amp!! Lol
DrNeutron wrote:I have an old i3 made from a kit (Sunhokey), also a CR10s and an Ender 3. Hard to beat the Ender 3 for a good started printer, it is c...
DrewDennis wrote:I use that same base. You need a very high infill and high wall count to make it sturdy. I printed my initial ones with PLA+, but am...
ukewarrior wrote:There are online services that will print anything for you. For the cost of buying a printer when you need like 16 bases. Lol Se...
DrNeutron wrote:Was it this one: Not a specific one. But this would work for me. Is there a way to buy them. I don’t have access to a printer. S...
They are in stock. My order was shipped yesterday.
using their pixels. in fact of my pixels are from them.
Bwinter wrote:I haven’t seen any group buys for the uAmp this year either (or last year). The group buy for the line drivers are expected to be at th...
Bwinter wrote:uAmp, line buffer or fAmp uAmp. That’s what it was. Where does one get more of those?
