I went to turn on tonight's program, and when I walked in the room I saw 93.9 glowing at me! It's a Christmas miracle! ... or this card could sense t...
Checked the 4 caps, and they all appear fine. The inductor is barely warm... just a barely noticeable temperature increase from the rest of the board...
I didn't feel anything that struck me as "hot". The only place that even felt slightly warm to me was the round piece wound in copper wire (wish I kn...
Thanks for all the great input. I did a bit more checking with it this morning based on your suggestions. I did a quick check of the solder joints a...
I hadn't thought to check the solder joints, but I will in the morning. Are there any common circumstances that cause these cards to die? If there's...
I checked it before I shut down for the night and I believe it was at 12.5 volts.
I found MegaTreeMaker in this thread: I assume it's what he was referencing. Chris, thanks for the info on 2.5. It looks like that'll be the key i...
I guess to preface this, I should say that I spend almost my entire day at work in Excel, so when I see a block of cells, my first instinct is to put ...
Mike, Thanks for the information. I hadn't thought about tying the right side to a neutral bar separate from the controller, but I think that'll be m...
