I built 2 8ft tubes last year. Just glued all of my sections with e-6000 glue and wrapped with clear packing tape. I used dumb RGB strips cut into 11...
Henri, You should bring all of the stuff you don't need anymore so we can have a fleamarket at the same time 🙂 barbotte wrote:ok so far so good ..h...
I'me gone for the next 2 weeks but the rest of August is free for me!!!! Randy
RobertB wrote:Then I would assume this type of controller would work; ....that is Randy if your daisy chaining the strips worked. Haven't tried ...
RobertB wrote:Randy - I wonder if other controllers that support the 9813 chip would work with these strips? What software are you using? Not sure if ...
Clyde L wrote:Just received my E682s 🙂 and also my bridge for connecting the Ray 27 channel boards. Reading the manual now on the e682s so I know w...
I just tested the strips with wires with alligator clips. I still don't know if i'll use 1 strip per connector or try to daisy chain them together.
Just use the type 7 chip (9813). Since the strips are all white leds I just configured the e68x with 36 pixels (108 leds/3 channels per pixel). Ra...
LabRat wrote:Banner cost 14.99, Banner discount 13.99, Shipping.. $35 Not such a bargain anymore. Last time it was $12 and change in shipping charges...
RobertB wrote:You might could get away with just supplying the power via the first of the daisy chain of strips...and it be fine. Just not sure if I w...
The patch is now available from Oracle. Randy
szaske wrote:I'm trying to build a wreath using pixel strips. I really love the close 1" spacing on my 2811 30 pixels/meter strips. But they are pre...
Thanks. Randy
iflights wrote:Here's GECEs at work on roofline, large tree, and door arch. Is the spacing between your GECE's 10 inches on the roofline? Randy
Re: Renard SS 2013 Group Buy Round 1 Hi James, 1 - Renard SS 16 BOM 1 - Renard SS 16 PCB 1 - Renard SS 16 Heat Sink Thanks again for doing this. R...
