pixelated
@pixelated
Eminent Member
Joined: Mar 19, 2021
Topics: 2 / Replies: 24
Reply
RE: Coro sphere as a tree topper

I am sorry but I cannot text you as I do not own a cell phone. Thanks.

5 years ago
Forum
Reply
RE: Coro sphere as a tree topper

I have tried to PM you but you are at the limit unless some messages are deleted.

5 years ago
Forum
Reply
RE: HiLetGO 12F

Please see Table 4.

5 years ago
Forum
Reply
RE: DMX 512 Relay board and E682 Controller

The 3 data wires will supply a maximum of 60mA at 5V at full brightness white. However, the coil pickup voltage of a 5V relay normally exceeds 60mA. ...

5 years ago
Forum
DMX
Reply
RE: Snowflakes Along Roofline

You could use roof jacks that are secured under the shingle tab.

5 years ago
Reply
RE: Christmas and Spring miniatures shows

That was amazing! I'm sure a lot of work went into making the two shows and would be enjoyed by many. Perhaps you will make more?

5 years ago
Forum
Reply
RE: Looking for a wiring check

I does cost to use Visio but if you are looking for something that is free try LibreOffice Draw. You can get a package of network shapes here:

5 years ago
Reply
RE: PICTURES: Building my matrix for 2018 (48x27 pix)

in the video it is stated that the 3 leds positioned in the 4 inch spacing make up a pixel, i.e. it is a 4 inch wide pixel. The 3 leds are controlled...

5 years ago
Reply
RE: PICTURES: Building my matrix for 2018 (48x27 pix)

Your original matrix has a spacing of 4 cm between pixels. The spacing of the pixels on the strip is ~4 inches (10 cm).

5 years ago
Reply
RE: Use of a 400W 36V 11.11A DC Power Supply for 12v Pixels ?

The dc to dc step down converter is rated for 350w and the power supply for 400w. This is

5 years ago
Reply
RE: Buffer/line driver - null pixel without pixel

Hello Rob, I placed an order on your sheet today. Thank you for making them available. Regards, Carl

5 years ago
Page 2 / 2