Thanks Randy! I'm trying to figure the best controller for this setup. This setup is almost fixed. It shouldn't change at any other point so install...
So Randy, you would install 1 power supply and one controller on each side? Is that it? And how would you setup the deck?
Xenia wrote:Pat, Did you decide on a controller. I am sorry but every time I look at your diagrams, I go back to two controllers, one on the deck an...
MrSmoofy wrote:I wasn't saying 10 was required just that you will probably need something bigger then 18 because of your longer runs and the use the 2...
Thanks for the info. When doing a power injection, how do you guys do it for the data if the strip needs cutting?
Skunberg wrote:Then you can pass it on to the next new person 🙂 I sure will 🙂
Skunberg, you are absolutely right. My bad about that. I hasn't thinking right when posting that. Thanks for the clear up, and eventually this will al...
Just another question, lets say I'd use a 350watts 5v power supply, thats a total of 70Amps. Which kind of breaker provides 70 amps when most are 15am...
How can I calculate if a 12/3 could do the job? It is a lot easier to find 12/3 extension cords than 10/3. Also, when using the power supply, can I ...
10 gauge? Isn't that wayy to big? Although if its 10 AWG Ill need... this would be 10/3 right?
Great. This is very valuable information for me 🙂
Shouldn't we be using something like this : for 30 leds? 5V/8A which would give 40 watts. I don't know much about electronics quite frankly and tha...
MrSmoofy wrote: These are the ones I have. Thanks... but I see that buck converter only provides 15 watts, where the minimum you can get with a 30 ...
This one looks promissing: But Id have to see how could I enclose it to be waterproof.
Skunberg, Thanks a lot for those links. I see a lot of those ebay buck converters are under 36watts... wouldn't that cause issue?
