i had a similar problem once while building a magic tree When I ran the power wire too close to the signal for communication there was a lot of inte...
what type of wire are you using to power and feed the signal to the leds. are you using a cat5 or a cat6 cable to feed power and signal? Sent from my...
if you are using the arduino make shore the ground from the power supply is conected yo the ground on the board and check the voltage after every 2 or...
i dont know if this helps but i run my setups in water tight boxes with foam in side i dont have any problems. see my pic . The boxes do have a vent s...
i have them permanent on the house used pvc trim and white pex 1/2 and made it part of the trim work. i have a post on that Sent from my SM-N975U...
i dont have any for v day but will try easter with light up eggs and house tim lights. and a projector at the window. Sent from my SM-N975U using Tap...
hay there i am new to 3d printing are there more sites like this you trust if so do you have a list of them if you could post. Sent from my SM-N975U ...
need to know your setup and display type do the other effects do the same Sent from my SM-N975U using Tapatalk
in vixen dor the header wen you use >>350>050
thats 1/2 inch pex Sent from my SM-N975U using Tapatalk
look led in pex Sent from my SM-N975U using Tapatalk
a bit of work but its working the glow is nice to in person looks very nice. Sent from my SM-N975U using Tapatalk
i agree pex looks good i made some and like them. Sent from my SM-N975U using Tapatalk
here is what i use on plug ends. for power supplys u can use rain proof out door 12v or 5v power supplys. Sent from my SM-N975U using Tapatalk
can i use this STARTECH.COM SLIM USB 3.0 TO VGA EXTERNAL VIDEO MONITOR ADAPTER USB32VGAES and set it up under the generic serial controllers. Sent f...
