so should I be able to just hook up wire 1,3,5,7 with the 24vdc to the + input of the mighty mini floods and the 2,4,6,8 to the (-) terminal and every...
I just got my vs 1 boards working after 3 days of trouble shooting. Turned out to be the pic programing. I guess reg pwm firmware will allow these b...
I remember a modification needing to be made to the vs 1 of the ren 24lv board. I'll look for it in a minute but for now the board seems to work for ...
according to that thread it doesn't look like it. Unless you are using a diff rs485 than I sent in the coop.
So to further test the board I installed the tranformer and tried to control some ssrs. Everything worked fine in that mode. I tried with some dcs...
I'm trying to replicate the set up in post #1. I've have a few questions that I haven't been able to clear up. Franks web site states to get a 40ohm...
******** There was an error in the wiki. It has been corrected but if you have built your boards already here is the info.
Thank you . 1 is rated at 500 volt and 1% Tolerance: . and the other at 250 volt and 5 % Tolerance: I'm assuming for the ren24lv needs this doesn...
Also While I'm asking. I'm using this for the mighty mini floods with 24vdc power supply. (which are awsome by the way) Quote for your ren 24lv in...
Looks like I forgot to order 680ohm resistors from the BOM. Can anyone tell me if these would be ok to sub with. I happen to have some of these fo...
Thank you everyone for participating in this coop. All packages will be dropped off for shipping today (Saturday). Unless I have pm'd you regarding a...
I'm sorry all that I didn't make the 31st goal I was shooting for. I have just finished sorting everything and will start packing thursday. If I don...
Just a reminder that you are adding 2 of these to my order for 2 ren 24lvs for combined shipping. Thank you Brad
I will be out of town for the next 4-5 days.
