komby
komby
@komby
Prominent Member
Joined: Oct 25, 2012
Topics: 53 / Replies: 818
Reply
RE: Want Wireless - for my system - but have no idea where to start

ThinkAgainAgain wrote:Thanks for all the insight! I'm still learning so this all great information. I assume the flow would be something like this.....

11 years ago
Reply
RE: Want Wireless - for my system - but have no idea where to start

is the transmitter most are using. It can handle 1-2 universes per transmitter depending on the data rate. You can also use your fpp and an expansio...

11 years ago
Reply
RE: Want Wireless - for my system - but have no idea where to start

ThinkAgainAgain wrote:can the RF1 function with 12V pixels? - Single universes is fine - was designed to control up to 170 pixels per receiver.

11 years ago
Reply
RE: Want Wireless - for my system - but have no idea where to start

The current hardware best practice with the komby gear is to use the komby sandwich transmitter to transmit 1-2 universes per transmitter. Each rf1 d...

11 years ago
Reply
RE: Want Wireless - for my system - but have no idea where to start

If you do consider the rfshowcontrol wireless setup a few questions : How many wireless pixels? For what type of props? The komby stuff works well ...

11 years ago
Reply
RE: Convert WS2811 to LPD6803

Rfshowcontrol and komby can output lpd6803

11 years ago
Forum
DMX
Reply
RE: Komby Issue and question on OTA

// OVER_THE_AIR_CONFIG_ENABLE Description: // Valid Values: OTA_ENABLED, OTA_DISABLED #define OVER_THE_AIR_CONFIG_ENABLE 0 // RECEIVER_UNIQUE_I...

11 years ago
Reply
RE: Komby Issue and question on OTA

What sketch/receiver are you trying to configure for Ota

11 years ago
Reply
RE: Komby Issue and question on OTA

michaelc wrote:Yes I'm using the 4.02 Rushdie control file. Where I the sketches do you set it for Ota ? I se an Ota sketch but it doesn't have any u...

11 years ago
Reply
RE: Komby Issue and question on OTA

All receiver sketches have an ota flag and they have a unique identifier. You then use the ota sketch on a komby sandwich . Once loaded you hit the...

11 years ago
Reply
RE: Komby Issue and question on OTA

As long as you are using the new code 1.0.6 while untested should compile and should work fine

11 years ago
Reply
RE: Komby Issue and question on OTA

1.6.x or newer are supported in the current release AND it must be 1mbps for 2+universes

11 years ago
Reply
RE: water proofing pixel connections

Rick Todd wrote:I used clear silicone with clear heat shrink and no problems.. third year Amen. I've used 4 tubes of silicon2 this year and its rea...

11 years ago
Reply
RE: Komby Issue and question on OTA

michaelc wrote:I'v scaled back my Komby network to 1 sandwich and two receivers but I'm having problems. Facts: 1) I have 1 sandwich broadcasting U20...

11 years ago
Page 2 / 59