Jeff Millard
Jeff Millard
@jeff-millard
Noble Member
Joined: May 28, 2007
Topics: 101 / Replies: 1349
Reply
RE: E1.31 6 port Bridge source code wanted

Steve, did you get any of your bridges working? I have some things that might help if you need them. I’ve got a spare RPM that works, but one port is ...

4 years ago
Reply
RE: LOR S6 Advanced?

Getting back to this, I’v finally gotten a layout (Preview) completed. All the minor annoyances aside (every system has annoyances, LOR seems to have ...

4 years ago
Forum
Reply
RE: Just Venting

TomL8345 wrote: If there was ever a need for a “like” button… This would be it! Jeff

4 years ago
Forum
Reply
RE: New SanDevices V5 firmware coming soon

Jim, just in case you stop by I have a question about the E682v5.038-01 FW from your store page. I added this to my only E682, and I notice on the Out...

4 years ago
Reply
RE: LOR S6 Advanced?

After a couple days spent looking for all the E1.31 devices I plan to use, I've finally settled on the network settings. The next annoyance I've found...

4 years ago
Forum
Reply
RE: LOR S6 Advanced?

An upgrade to Pro was cheap, and it seems I get some of the effects that are available in XLights. I’ve stopped sequencing and am now checking all the...

4 years ago
Forum
Reply
RE: LOR S6 Advanced?

Next Thing. Making a 360 Wedge Mega with 12 slices using 3 16-channel controllers. Add a 16-channel controller, select the first channel and create a ...

4 years ago
Forum
Reply
RE: LOR S6 Advanced?

First issue. When naming props in a preview, they automatically sort in alphabetical order in the preview bulk list. When I hit 2 controllers worth of...

4 years ago
Forum
Topic
4 years ago
Forum
Replies: 20
Views: 11693
Reply
RE: Hemera Direct Drive and Hot End

The rest of 2021 was spent buying a new home, then flipping and selling the old place. I hadn't touched a 3D printer in over 9 months. Needless to say...

5 years ago
Reply
RE: Hemera Direct Drive and Hot End

Here it is: All direction was taken from YouTube TeachingTech and Chris' Basement. The following describes the firmware changes I made for the Creali...

6 years ago
Reply
RE: Hemera Direct Drive and Hot End

It was much worse than I imagined. The home point is flipped on a Ender 5. (It was what should've been changed first, so I had to do everything over a...

6 years ago
Reply
RE: Hemera Direct Drive and Hot End

Everything is set up but the Start and End GCodes in Cura. I just really burned out this afternoon and took a break to watch TV. I tried to print some...

6 years ago
Reply
RE: Hemera Direct Drive and Hot End

Took a couple days, but I got the configuration files edited and the firmware compiled and installed. Now I’ve got a good base to work from so I can s...

6 years ago
Reply
RE: Hemera Direct Drive and Hot End

First day spent downloading and installing then editing settings for an Ender3 as that's all I have to work with so far. The BLTouch is connected and ...

6 years ago
Page 2 / 97