Why would they run auto-update on a no-longer-supported operating system? The updates are still there, but will not be added to any further. Microso...
tomperro wrote:So, let me get this right... If i want to do rgb i would need a channel for each individual led bulb? Sent from my VS930 4G using Tap...
Good to hear you found your problem. Most of what I say below no longer applies in this case. It doesn't take much to get a ping packet through; ICM...
Interested in at least one of each.
dmcole wrote:Hmm. Since we're not licensed users of the spectrum, I wouldn't think there is a place where we -shouldn't- be as long as we're not stepp...
I have a 2"x8" cut in half, tied together with rope, and one piece each side of the peak. Left side, looking at the front of the house, I have two w...
DDOS attacks can be mitigated, but are hard to stop entirely. I've done it, but it's something of a trial-and-error thing, working with the end user ...
Johnfish211 wrote:You can do it all in LOR, as long as you have the hardware to implement your ideas. Jack, If you have information on how I can i...
Ralph Deweil wrote:Well i have been using LOR forever, no complaints, its users are some of the best and helpful people i have ever talked to, no disr...
Skunberg wrote:I can't get any of these to make toast. Sent from my SCH-I545 using Tapatalk Yeah, but neither can LSP. I've seen at least one per...
My dogs used to eat the coax and such going to the satellite dish outside. They're over that now, although the lab - 10+ years old now - is still an ...
rfallatt wrote:Can you hook up the potentiometer with the highest resistance setting and adjust ... Then measure the pot setting to get the resistance...
CaptKirk wrote:If you are just replacing a few bulbs, remember that the pot only needs to dissipate the power equivalent of the missing LEDs at approx...
CaptKirk wrote:Give it to a friend or neighbor and get them hooked... Yeah, it's a "gateway drug." Got you hooked, didn't it? Mine went to my son ...
CaptKirk wrote:Lets assume full wave conversion- you get a decent 170v DC rectifying 120v AC. LEDs are typically 20ma. Then you need the voltage dr...
