It’s most likely the PIC or the transistors.
Usually 1 channel ON and nothing else is a firmware issue. Try reflashing the first chip.
I'll take them. Sending you a PM.
davdue, I'm going to send you a PM
No.....I wasn't really clear. If you are using the programming header on the Ren-C without removing the chip then just power the board. If you are u...
Connect +5 and Ground directly to the Ren-C
That's a fairly common and well known issue with USB ports, especially on laptops. You can still use the laptop, you just need to power the board wit...
For what ever reason your Pickit3 is not seeing the PIC16F627A. A couple of things come to mind. First how are you connecting to the chip, are you ...
Using your method of connecting the ZC signal to the REN-C has nothing to do with Q1. You can actually remove R1, R9 and Q1 as they aren’t needed whe...
No problem. Keep us posted on your progress.
The schematic shows the pull-up resistor. It’s R2, just above the transistor on the schematic you attached above. Connect your ZC signal to Ground a...
Also you shouldn't need to a a pull up resistor to your ZC circuit. The Ren-C has a 27K pull up on the circuit board.
I'm about 50 miles from Jon. Heavy rain for several hours three different times. Aabout 5" total. We live on one of the highest lots in town and ne...
I also have 2 of the RENARD-16 boards that I would let go. They are a little different from the SS8 series boards. They do the same thing but with 1...
How many boards are you looking for ???
