Danevandy99
@danevandy99
Eminent Member
Joined: Nov 15, 2014
Topics: 10 / Replies: 19
Reply
RE: First Year Videos

Nice job! What controller are you using?

12 years ago
Forum
Reply
RE: How is your setup going?

All was going well until I hit a few glitches. My music is a second off (I use Helix), and the other issues seems to be cable related. Everything is...

12 years ago
Forum
Topic
Reply
RE: Random SSR channels not working

I am using SPT-2 wire and plugs. Could the thicker insulation be causing a bad connection?

12 years ago
Forum
Topic
Forum
Replies: 2
Views: 3169
Reply
RE: Helix V3 main board + Helix Network Supervisor Questions

Do the headers on the main Helix board have anything to do with what mode it is in?

12 years ago
Reply
RE: Helix V3 main board + Helix Network Supervisor Questions

blantrip wrote:#1 - Don't know if this will help, but make sure you select the correct MP3 player (VS1053) during your setup? Also, make sure your mp...

12 years ago
Reply
RE: SSRneon mounting in Ta-200 help

I ended up using tjetzer's method for removing them with a heat gun. After I heated up the studs for about 25-30 seconds, I used a wrench to pull them...

12 years ago
Reply
RE: SSRneon mounting in Ta-200 help

tjetzer wrote:Heat the studs up with a heat gun and pull them straight out. A high powered hair dryer may also do it. Have you tried this before tj...

12 years ago
Reply
RE: SSRneon mounting in Ta-200 help

This is how the SSRneon sits in the TA-200 now. The studs that I circled in yellow are the things I'm asking for advice to remove. I'm hoping to us...

12 years ago
Reply
RE: SSRneon mounting in Ta-200 help

Remove the bottom set of nuts and bolts.

12 years ago
Reply
RE: SSRneon mounting in Ta-200 help

Yes. Do you know the best way to go about doing that? This is a SSRneon G2 ukewarrior.

12 years ago
Topic
Replies: 24
Views: 14824
Page 2 / 2