cscool36
@cscool36
Estimable Member
Joined: Aug 2, 2010
Topics: 16 / Replies: 58
Reply
RE: Vixen, Triggers, and Teensy byt PJRC

Hi Lee, Thanks for all your help. After installing Direct X, It is now working. Thanks again. Colin. :lol::lol::lol:

15 years ago
Reply
RE: Vixen, Triggers, and Teensy byt PJRC

I have now tried with safari on the xp machine. All The code is now working 96-102. I am also getting an error in vixen. Error when initializing load...

15 years ago
Reply
RE: Vixen, Triggers, and Teensy byt PJRC

Hi Lee, I only getting the code on the screen on my Mac. The Mac does not have vixen on, so I can not test. The 2 laptops and also one from work, all ...

15 years ago
Reply
RE: Vixen, Triggers, and Teensy byt PJRC

Hi Lee, Just tried the code again. Went to the we site and tested the key board. I tried it on my Mac and it worked no problems, then I tried on the l...

15 years ago
Reply
RE: Vixen, Triggers, and Teensy byt PJRC

Hi Lee, Thanks for your help. Just done a trigger. I can not get the numbers key pad to work. I am using an old laptop with xp. I have checked in word...

15 years ago
Reply
RE: Vixen, Triggers, and Teensy byt PJRC

Hi Lalder, I am looking for help to make a trigger from a push button switch to start the vixen running. Can you please help me. I am running vixen 2....

15 years ago
Reply
RE: RPM DMX 16 DCssr Help

Thanks Robert, I will try this week. I Can not find IC 5 but have a IC 7 (LM2574). I am guessing that pin 1 is where the dot is. Can I leave in C1,D2...

15 years ago
Forum
DMX
Topic
Forum
DMX
Replies: 5
Views: 3663
Reply
Topic
Forum
Replies: 6
Views: 2265
Reply
RE: RPM 240 volts DMX ssr controllers Ch 4 and Ch 16

Hi Mac, I also have some PT138 800 on 3 controllers with was built by Matt Edwards which I think are not isolated?. I will take off the heat sink tomo...

15 years ago
Reply
RE: RPM 240 volts DMX ssr controllers Ch 4 and Ch 16

Part number BTA06-600SRG as per RPM's Bom.

15 years ago
Topic
Replies: 6
Views: 2715
Topic
Replies: 1
Views: 1594
Reply
RE: Plug In Error Sequence Preview

Hi Joel. I have changed the channel names in properties and the colour as well. If I do a new sequence with no profile it will work. So, I open a new ...

15 years ago
Page 4 / 5