cscool36
@cscool36
Estimable Member
Joined: Aug 2, 2010
Topics: 16 / Replies: 58
Reply
RE: Vixen iPhone App

Hi All. I now can say that I know how to fix the "Unknown Client" error. when you go into the add-ins and select the remote client you need to tick, "...

13 years ago
Forum
Reply
RE: Vixen iPhone App

Has anyone solve this problem?? Error:Unknown client "vixen" Thanks Colin

13 years ago
Forum
Reply
RE: Dmx 4 ssr

Hi Stgtech. Is this RPM board? I would like to get my hands on some too. I used 5 of these boards and they are great, no problems. You can try. This w...

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

OK I have 1 set of 300 incandescent 24 volt and measure 0.7mV. Channel 3. I guess I just need a little load on each channel. Thanks Colin

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

Hi David, Just added a 4.7k resistor to channel 4 output with lights off and measured 2.5mV. the other channels 1,2 and 3 still measured about 3.3vac....

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

Ok I have removed the bridge and now using a 12vdc power supply corrected to the 1000u capacitor. All is working. I have measured the output voltage o...

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

I have attached some photo. I have bridge one side where the transformer was and the resistor on the other side. Being power by the 24v AC power suppl...

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

Hi David, I tried last night with no luck,but I did notice about the zero crossing. I ended up trying some resistors until I got about 12 volts. I am ...

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

Thanks David_AVD I will try. Thanks Colin

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

Hi David The C1 capacitor is 1000uf 25 volts. I got the gate resistor from my renard 16 as it has the same Triacs 6 Amp 600 Volt and running 24v ac. T...

14 years ago
Forum
DMX
Reply
RE: RPM's DMX4SSR 240V ac

Thanks for all you information. The transformer is 240 - 6V ac 0.5VA, so if I use a 6 to 12volt dc regulated power supply, I can remove the bridge to ...

14 years ago
Forum
DMX
Topic
Forum
DMX
Replies: 19
Views: 5663
Reply
RE: E681 Problems with universe 4

Thanks Rokkett and Budude. I will try tonight. Colin

14 years ago
Topic
Replies: 5
Views: 2782
Reply
RE: E68x to DMX converter

Hi Budude, Thanks for the update, Still interest in getting some boards (5). I will try my prototype again with updated schematic. Colin

14 years ago
Page 2 / 5