As a newbie myself, I would say a sticky on the forum listing everything may not be the best way to go. I know alot of us would not take the time to ...
Re: Here's another "have you tired" thread Thanks LightUp! I did miss it. I have updated the code a bit. This is something I am tinkering around w...
Re: Here's another "have you tired" thread I would like some of the guru's here to take a look at this sketch and let me know what you think. I have...
What size resistors did you use with the TIP120's?
I am sorry for digging up this old thread, but I have looked for the BOM for the inline SSRs and can not find it anywhere. Does anyone know what tria...
Jetty, those are all great ideas for version 2. I'm starting on building version 1 basically. I may have to get a hold of you if I run into problems...
I have an old computer power supply that I can tap a 12VDC source from..........but now the question becomes would the power supply have enough umph t...
Thanks for your input victor. The PCB board shape was an accident. This is the first PCB I have tried to lay out. It is going to controlled by an U...
stallionent wrote:OK, I understand now. Thanks. I don't see a problem as I can put my rarely used laptop inside the control cabinet on the shelf. I wi...
Thanks for the comments. I'm trying to learn all of this. I had a simple 16 Channel Mechanical relay setup this year and the bug has bitten me big ti...
Told ya I was new to this. Here is the picture with the traces. IC1 is 74HC595, Ic2-IC9 VO2223A, R1 is a 680 Ohm resistor.
never mind it was my ISP being stupid. I bypassed their DNS servers and found it
