Evening, all;
This year I'm planning on adding 12 wireframe snowflakes to my roof. I've got the snowflakes, now I'm trying to figure out how to secure them to the roof. Does anyone do this, and if so, how do you secure yours??
Thanks!
Mike
BTW, I'm planning on laying them flat on the shingles. Thanks.
Sent from my SAMSUNG-SGH-I337 using Tapatalk
I don't have a roof facing the street so I only put a star or snowflake at the peak. But I've seen what your talking about done a zillion ways. Using clips for light strings to hold things. I've seen wires go over the peak to a sand bag to hold things. I've seen a pole attached to the gutter that goes up to hold them. I've seen people run horizontal wires across the roof and hang them off the wire. I've seen frames built to hold them. The list goes on and on.
I just laid my snowflakes flat on the roof with the power cord zip tied to my ridge line. That keeps them from sliding down, but would allow them to swing side to side, but I never saw that happen. What did happen is that laying them flat on the roof allows them to collect water and leaves in my "non-snow" area. That killed my snowflakes that used bulbs, but not the ones made from rope light which survived fine. I would recommend you put a couple of vertically placed 1x2s or short pieces of PVC under each snowflake so that debris and water will flow underneath the snowflakes.
Thanks for the replies, guys. I figured there was probably a multitude of ways to do it, but when I do a search, most of the threads that come up are for attaching reindeer, sleighs, and wireframes that must be propped up. I had thought about using shingle clips, but am not real wild about using them on the front side of the shingles. Was thinking about using some sort of wire/sandbag method, and thought I'd get some opinions from those that have done it.
Good idea about using some 1x2 to keep the snowflakes off of the roof for water flow. Thanks!
Sent from my SAMSUNG-SGH-I337 using Tapatalk
