Here's what I've done so far.
I went out to Altoona lights and used their Calculator.
http://www.altoonalights.com/star_calculator/star_calculator.html
I made a jig on a 4 x 4 piece of plywood.
I used 12 gauge galvanized steel rods, 4 foot long and cut to length.
I made one complete star and then 2 half stars.
I welded 1 half star on the front and 1 half star on the back of the full star to get a 3-D star.
I added some extra wire in the center to strengthen the unit.
This is my completed 3-D Bethlehem Star skeleton.
Very nicely done!
You know that is going to take a special 3d sequencer.... Hmmmmmmm. :biggrin::):):):biggrin::biggrin:
Shut up I just blew my budget for this year!
No seriously, what's a 3-D sequencer!?! Are you pulling my leg?
Great job! I like it.
IaRoadKill wrote:No seriously, what's a 3-D sequencer!?! Are you pulling my leg?
Yes I am.... However it would be a thought if you had pixels that were "nested" inside objects. Like boxes or stars.
IaRoadKill wrote:No seriously, what's a 3-D sequencer!?!
sequencing software or an effects generators that is 3D-aware. The currently available tools use 2D effects and those mostly look okay on a 3D prop, but there are certain types of effects that require the effects generating software to be aware of 3 dimensions in order to look correct in 3D. For example, if you ran a 2D exploding star effect on a 3D star you would need to arrange the pixel order so that the first lights to turn on are all in the middle of the star and the last ones to turn on are all at the outer tips of the star. It could be made to work, but it's more manual effort to set up than just using a 3D-aware effect generator in the first place.
don
It wouldn't need to be 3d aware. You could have it setup as 3 flat stars (or 4 depending on your star) and you could have them explode together like having 3 arches jump together. 3d aware would be way better but you can get around it.
Great design, I want one now! Waiting to see the next steps. Great work.
BillW





