Grid is Patching in...
 
Notifications
Clear all

Grid is Patching in Reverse

17 Posts
3 Users
0 Reactions
3,801 Views
Posts: 752
Topic starter
(@popo-b-trippin)
Prominent Member
Joined: 13 years ago
[#56949]

This one is a bit tough to explain, but here it goes...

I have a grid that's 7 tall by 135 wide that I am controlling with two different expansion boards (I prefer to use a grid for the icicles). The first part of the grid is patching correctly (from left to right, top to bottom). When I patch the second part of the grid it's patching starting from the far right end (meaning the very last pixel) as the first pixel in the set. Nothing is zig-zagged or reversed. It's simply patching from the back-forward.

It may or may not be important to note that I do have other props in-between the split in the grid; I patch the first set of the grid, then a set of roof lights, then I patch the rest of the grid.

Here is a very rough pic of what's happening;

Patch issue

Any thoughts/ideas as to what is going on or how to remedy this?


16 Replies
Posts: 752
Topic starter
(@popo-b-trippin)
Prominent Member
Joined: 13 years ago

I found a work-around, but it still doesn't explain why it's doing that.

The work-around was to patch the second half of the grid row-by-row. Not efficient, but effective.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

can you send a picture of how the groups are set up and another of the patching settings you are using


Reply
Posts: 752
Topic starter
(@popo-b-trippin)
Prominent Member
Joined: 13 years ago

So I was wrong... The first set is also mapping in reverse.

Out of the 135 rows, I'm trying to patch the first 75 initially. To do it I highlighted row 1-75 and just hit the patch button. For the second half I highlighted 76-135 and hit the patch button. The preview shows row one as the first set, as it should be. But when connected to the controller, the first pixel is showing up in row 75 rather than 1. The same applies to rows 76-135; when connected to the controller the first pixel is from row 135 rather than 76.

I know I'm not explaining this well, but I don't know how to explain it as it doesn't make sense.

Martin, let me know what else I can provide to help diagnose.

On a side note; the mega tree patched properly, so I don't think it's a setting in the controller (Falcon F48).

Patching
Layout

Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

What is the order of elements in the Grid 1 C1 group (picture)
What is the current relationship (patching) between grid 1 C1 Top pixel and channels on the controller?


Reply
Page 1 / 4
Share: