I'm having an issue with the scrolling timing bar when using the waveform tool.
During any time where there is no Blinky-flashy, the bar works as expected. Once the blinky starts the bar disappears.
I upgraded from 2.5 (because of this problem), to 2.0.8. It does it too.
Brad
I guess from the lack of responces compared to views of this thread, I am the only one having this problem....ummm:confused:
Is it possible to go backward to say v. 2.0 and retain my current profile and seguences, to see if the problem goes away?
Brad
I'm not sure if this is related to the time bar issue or not but,
the "beat" track does not work properly either.
I made a beat track using the "new sequence wizard". Every thing looks correct, and is aligned with the waveform, so the timing should be right.
When I play it back using picture viewer, the light timing is not correct at all. It will be right on for a few beats then skip several beats, then be off beat for several beats. Then finally catch up and be on beat again.
The music is a consistent 2 beats/sec. I've tried 25mS, 50mS and 100mS. Output plug-ins are Olsen 595, EnTec Pro, and picture viewer. Using same laptop as last year.
Last year I used Vixen 1.1. Did not have this problem.
Any suggestions would be greatly appriciated.
Brad
can you give give some more information please.
with my 100% cpu problem i am finding that the line that scrolls left to right over the sequence comes and goes and is erratic. is this what you are seeing or is it just not there at all when you start the sequence.
also maybe check your cpu usage and see what it is as well while running the sequence
Peter
while you are watching all this, is the adjustable preview running but minimized? If so, turn off that plug in and try it, it could be the picture file is too large.
