multiple Sound Devi...
 
Notifications
Clear all

multiple Sound Devices within the same sequence?

7 Posts
2 Users
0 Reactions
1,344 Views
Posts: 150
Topic starter
(@alwysrit2)
Estimable Member
Joined: 19 years ago
[#501]

This will probably be a change request, but is it possilbe to assign songs to multiple sound devices within the same sequence? We are setting up to have 4 talking skulls and it is looking likely that I will be using 2 different sound devices to get the 4 channels.
Thanks


6 Replies
Posts: 705
 KC
(@kc)
Prominent Member
Joined: 20 years ago

Ooo, that one may have to wait. You can assign different audio devices on a sequence basis, but not on a channel basis.

By the way, I'm still looking into your PSC issue. I have a ticket in with Parallax.


Reply
Posts: 150
Topic starter
(@alwysrit2)
Estimable Member
Joined: 19 years ago

I need to play with this more. If I can assign audio to separate devices by sequence, that might work. I am currently building the system with the 2 sound cards..waiting for w2k to download the Service packs.
The PSC got better when I slowed the sequence down to 100ms. I think it is an issue with the slow baud rate it defaults to. Is it possible to increase it?
By the way, have you recieved the 8055s?
Thanks


Reply
Posts: 150
Topic starter
(@alwysrit2)
Estimable Member
Joined: 19 years ago

System has finished building and hardware is working fine. I tried to build 2 sequences and assigning a different audio device to each one, but it looks like the audio device is set at the Vixen level instead of the sequence level. Am I missing something, doing something wrong????
Thanks
-Don


Reply
Posts: 705
 KC
(@kc)
Prominent Member
Joined: 20 years ago

The baud rate for the PSC is either 2400 or 38400, and the plugin always tries to make sure it's at 38400.

Well now I feel a bit stupid. I put in the back-end functionality for the sound devices but not the UI for sequence-level adjustment.

And no packages today. 🙁


Reply
Posts: 150
Topic starter
(@alwysrit2)
Estimable Member
Joined: 19 years ago

K.C., When I do the plugin setup for the PSC, I have a list of serial ports and I see the baud/parity, etc. but the drop downs aren't enabled. It shows it as 2400. Is that what it is actually using?
Thanks


Reply
Posts: 705
 KC
(@kc)
Prominent Member
Joined: 20 years ago

The PSC requires that you initially use 2400 baud to communicate with it at power-up. After that, you can take it up to 38400, which the plugin does. The plugin won't even try to run at 2400. If it can't get 38400 from the PSC, it will throw an error.

What's getting me about this is that the plugin is communicating with the PSC, it's doing so at 38400, and the data is well-formed (or so reports the port monitor). I'm guessing that I'm assuming something incorrectly, so I'm hoping the Parallax support people can help me with that. That reminds me, they haven't written back in a few days...


Reply
Share: