I am new to light sequencing and I don't quite understand how and where ssr's go. I plan on using a Renard board and I'm not sure how to connect and how ssr's work. I'm sure this question has been answered a million times but if someone could provide a link to a video explaining or provide any info I would appreciate it.
Korey
If you are looking at AC boards then there are two major variants - those with on-board SSRs such as the RenSS or RenPlusTR series and those with separate SSRs such as the Ren64 or RenZilla. The on-board style boards are a bit easier to build and use since there's a single board. The off-board versions basically break off the SSR (the bit that switches on/off the line AC) to a separate board but you can really think of it as just an extension of the on-board versions. The logic signals (5v level) come straight off the PIC microcontroller and power on/off an optoisolator that in turn switches on/off the main TRIAC that turns on/off the lights.
I have a presentation that's a bit dated in the Wiki if you want to review that - http://doityourselfchristmas.com/wiki/images/5/5b/Renard-Presentation-2012-08-17.pdf
Wow, very good presentation. Need to file that one.
As usual, Brian gives a great overview.
I have one observation: I switched from separate SSR systems to on-board SSR systems between my first and second year because I had a number of failures during shows and off-board SSRs represented three extra potential points of failure (the connector at the controller, the signal wire itself and the connector at the SSR) that on-boards just don't have.
HTH.
\dmc
That's funny. My first two years were onboard ssr's. And I started to switch to separate ssr's because I'd have less high voltage extension cords in the yard and more cat5.
Skunberg wrote:That's funny. My first two years were onboard ssr's. And I started to switch to separate ssr's because I'd have less high voltage extension cords in the yard and more cat5.
I'm the opposite - - went from Helix/SSRs (4x Oz style) to FreeStyle/SSRs (4 and 12's) to no AC at all and now have three RenSS16's solely to blanket my tree with ~150 strings of cheapo 1/2Wave strings I converted with the FWC boards. I had so much Cat5 for SSR runs along with ~40 extension cords it was a PITA setting up...
With ren24s 24 extension cords going here and there was adding up fast. Now I only have two leaving the garage. One to the megatree and one with plugins along it going to everything else. So much easier to have two extension cords and two cat5 going under the garage door rather than 15 extension cords. Not as bad as the guys that mount all the controllers on the garage wall and have hundreds of cords coming out.
