Notifications
Clear all

Power issue?

8 Posts
7 Users
0 Reactions
3,063 Views
Posts: 41
Topic starter
(@mickisdaddy)
Trusted Member
Joined: 5 years ago
[#54865]

Okay here is the situation I am running into I am a total newbie to all of this. I am soldering (new to that too) pigtails onto the bullet pixels I purchased. When I plug them in to my Alphapix controller to test I can't even go the full string of 50 pixels before the colors are not the same. Of course it is most noticeable with white. When I plug in a second set of lights it gets way worse. What is the likely cause? Crappy pixels, bad soldering, crappy power supply (I had to replace the 12v with a 5v because of my bad ordering) or something else.

If it is the pixels hopefully I can get some good ones before I setup my mega tree.

Frustrated Newbie


7 Replies
Posts: 41
Topic starter
(@mickisdaddy)
Trusted Member
Joined: 5 years ago

I replaced the power supply because I ordered 5v pixels and a 12v power supply originally


Reply
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago

Agreed, also if you’re new to or not confident in your soldering skills I would try the solder and seal connectors.

All you need is a heat gun, then you slide one onto one side of the wire, strip and twist the wires together, slide the connector over and heat it up! The shrink wrap will shrink and the adhesive melts to waterproof the connection. Then you’ll see the solder in the middle melt and secure your connection. Ive used them in my whole display and they are awesome!

Ginsco 200 PCS 22-18 AWG Solder Seal Heat Shrink Wire Connector Kit Waterproof Connector Kit with Case Red https://www.amazon.com/dp/B098JQXK1T/ref=cm_sw_r_cp_api_glt_fabc_45CEPVQ65WKD6NAGGSDG

Sent from my iPhone using Tapatalk


Reply
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

I use mostly 5v pixels. I inject every 50 pixels so I don’t have any issues.

Sent from my iPhone using Tapatalk


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

I too use 5V pixels and PI for every 50 pixels (100 pixels with PI at both ends) If you are seeing color change at less than 50 pixels, my guess would be the wire used between the pixels themselves. The thinner the wire, the more voltage is lost. I always try to purchase pixels that "SAY" they are 18AWG (they never are). A lot of the less expensive pixels will use a much smaller AWG and cause issues like you are reporting.


Reply
Page 1 / 2
Share: