Notifications
Clear all

Renard PX1 fail

16 Posts
6 Users
0 Reactions
4,560 Views
Posts: 87
Topic starter
(@waites)
Estimable Member
Joined: 14 years ago
[#41673]

Hi everyone, I have 5 PX1 units, 3 of them work perfectly, but the other 2 they work for about 5 min, and then stop working. I was wondering if the fail could be for over heating or could be something else that I cant troubleshooting with. Thanks for your help


15 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

You might swap the PIC in a "bad" one with the PIC from a good one and see if that makes a difference. Then you'd know whether the PIC is the problem and possibly reflashing it may solve the issue. If not, then you know it's likely not the PIC -- try swapping the 485 chip from a good one to the bad one and see what happens. If that solves it then you know it's that chip. Otherwise, test the voltage output of the regulator -- it could be dropping out after it heats up. This is more likely if you're putting 12vdc through the board; if you're using only 5vdc, then the regulator won't get very hot.

Another problem that come up is also heat-related: as the board warms up, solder joints may expand and create a connectivity issue. You might remove the chips temporarily, reflow all the soldering and try it again.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Check the voltage first. Also if you are using 5V then the regulator is bypassed and should not generate any heat. Check the caps on each side of the regulator. If they are heating up then they are bad. Then do the chip swapping. If the voltage is sagging then you will not be doing any damage to the chips. But if the regulator is failing and increasing the voltage then you CAN damage the chips. Better to know before you put in a working chip and turn it into a non working chip.


Reply
Posts: 87
Topic starter
(@waites)
Estimable Member
Joined: 14 years ago

Hi Martin and Dirknerkle, Thanks for your help. I checked the voltage out of the regulator. I checked from the right to the middle leg and I got 4.5v and from right to left legs I got 5.5v. do you know how many volts are suppose to be?


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

The 7805 should be configured as in the pic. The middle is ground. The left pin is the input voltage and the right pin is the output voltage.

7805 1 500x416

Reply
Page 1 / 4
Share: