Renard/e682 opinion
 
Notifications
Clear all

Renard/e682 opinion

24 Posts
10 Users
0 Reactions
7,006 Views
cwalkeree
Posts: 173
Topic starter
(@cwalkeree)
Estimable Member
Joined: 15 years ago
[#41231]

In your opinion, is it best to go through Renard SS before going to e682, or vice versa, or does it not matter?


23 Replies
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

What are your plans? Incands or pixels?


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
cwalkeree wrote:In your opinion, is it best to go through Renard SS before going to e682, or vice versa, or does it not matter?

I'm not sure I understand the question - Renard's do not daisy-chain to E682's. An E682 output can drive a Renard (any) but not the other way around...


Reply
cwalkeree
Posts: 173
Topic starter
(@cwalkeree)
Estimable Member
Joined: 15 years ago

Thanks Brian.. I'm new to pixels.. Doing a show in April for autism awareness and just got my 100 pixel strings today.

I have a mix of 6500 pixels (e682), 4-7 segment incan posts and 3-7 segment Incan arches (SS24).

I may have bit off more than i can stomach and I'm a little more than stressed about the deadline, so i was just gonna try and get a quick response regarding the configuration.

Thanks again


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
cwalkeree wrote:Thanks Brian.. I'm new to pixels.. Doing a show in April for autism awareness and just got my 100 pixel strings today.

I have a mix of 6500 pixels (e682), 4-7 segment incan posts and 3-7 segment Incan arches (SS24).

I may have bit off more than i can stomach and I'm a little more than stressed about the deadline, so i was just gonna try and get a quick response regarding the configuration.

Thanks again

Well - a single E682 can only do 2040 pixels in unicast mode and only 1190 in multicast mode currently (Jim is working on new code to support more) so you would need more than one - in fact you would need four to do all 6500 and drive your Ren24's... April may be hard to meet - especially if you are new to all of this. I would definitely look at toning down things a bit anyway - no need to stress out too much! I've been using my upgraded E681's (essentially an E682) to run my Renards for several years now - works great - no silly USB dongles, etc.

Maybe concentrate on the Ren24/Incan stuff first and get it done and then see where you are at - - just a suggestion...


Reply
Page 1 / 5
Share: