Quick question abou...
 
Notifications
Clear all

Quick question about E682

5 Posts
4 Users
0 Reactions
1,644 Views
Posts: 447
Topic starter
(@blackbeard)
Honorable Member
Joined: 18 years ago
[#29966]

The manual for the E682 indicates it can be configured to output raw DMX. I use DLA equipment, Lynx Express and their dongle and TX/RX modules. Does this mean that if I build the proper cable then I can use my stuff directly from the E682?

Sent from my SPH-L710 using Tapatalk


4 Replies
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

I am using it (e682) to output to a dmx fixture (and renard as well on another cluster) and it works like a charm. So I would venture to say that provided it (your other boards) can take in dmx, it should work with the correct cabling as you mentioned.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
Blackbeard wrote:The manual for the E682 indicates it can be configured to output raw DMX. I use DLA equipment, Lynx Express and their dongle and TX/RX modules. Does this mean that if I build the proper cable then I can use my stuff directly from the E682?

Sent from my SPH-L710 using Tapatalk

Yes.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Right from the manual-

Outputs, in groups of 4, can be selected for “balanced” 2-wire operation, to drive
standard wired DMX devices. In many cases this will eliminate the need for separate
hardware to handle traditional wired DMX fixtures.


Reply
Posts: 447
Topic starter
(@blackbeard)
Honorable Member
Joined: 18 years ago

So many "conditions" like 'raw' and 'balanced', I wasn't sure
that equalled what my Lynx considered standard.
Thanks for the clarity.

Sent from my SPH-L710 using Tapatalk


Reply
Share: