Power injection que...
 
Notifications
Clear all

Power injection question

11 Posts
5 Users
0 Reactions
3,790 Views
LightUpMA
Posts: 208
Topic starter
(@lightupma)
Estimable Member
Joined: 15 years ago
[#38889]

Hi I'm wondering if anyone can provide a little clarity on power injection with ws2811 12v pixels. I have an e682 with a 350 watt ps running just under 600 pixels. The pixels with 30 ft of wire before the first pixel are flickering. Originally I was using 3 10 ft 3-wire extensions which I got from diyledexpress. So I used the t wire for power injection from a second 350 watt ps 3 ft from start of pixels. I removed + coming from 682 and sent ground and data only. I sent + and ground from second controller into the T and into the pixels and not much happened. After three days of reading up on the wiki and a few other places I have given up on the extensions - thought maybe too many connections in one line. I then took 30ft of spt2 from the controller and now it works fine.

However, I feel like this should be a teaching moment. I thought I was doing it right but I missed the boat somewhere. Would anyone care to weigh in?? My only other thought was since I was using 3wire waterproof cables still at that point I'm wondering if I was loosing voltage running to pixels and also back 30ft to the controller (but + was not connected to controller). I will also add that I check there was 12v coming from ps and after the first 21 pixels I tested and got 6v.


10 Replies
Robo
Posts: 1494
 Robo
(@robo)
Noble Member
Joined: 14 years ago

At that distance you might need a null pixel. Might be losing the data signal. I had this issue with my 13 arches. Added one pixel to my longest run and solved my flickering issue.


Reply
Posts: 1344
(@mrsmoofy)
Noble Member
Joined: 12 years ago

What gauge was the wire that was giving you problems.


Reply
LightUpMA
Posts: 208
Topic starter
(@lightupma)
Estimable Member
Joined: 15 years ago
MrSmoofy wrote:What gauge was the wire that was giving you problems.

18 gauge. I replaced it with 16gauge spt2 wire with better insulation.

I guess I just don't understand the mechanics of injection itself. I followed the wiki. Maybe someone has better way of explaining or even better a picture.


Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

There are a couple of things to consider.

First is the power. One way to check to see if you have a power issue is to leave your power as is and connect your data right at the beginning of the pixel string. Use a short cable, something less than 6' Turn them all on white. You should not see flicker. If you do, you may have power issues.. Rather than flicker you will most likely start to see a point where the color temperature starts to become a bit more yellow or pink (depends on the pixels). If that happens you need to inject power at some point. However, this should clear up any issue with power causing the flicker.

Now the data path. 30' is a distance that some have gotten away with while most others are not so lucky. If the first test comes out good and you have adequate power, than you should either use a pixel extender setup or add a null pixel or maybe even two. I have had situations where null pixels worked when testing in the shop but not when multiple data cables were bundled together. (Too much cross talk with unshielded cables). Add one null pixel in the middle and see it that works for you. If not you may need two of them.

In any case, eliminate one issue at a time. You will find it much easier to obtain good results that way.

Craig


Reply
Page 1 / 3
Share: