I probably shouldn't say absolutely. It's possible it fixes it, and if that's the case then you've got garbage on your port at the end in your Xlights layout.
Rule of thumb is that you inject power for every 100 pixels @12v. Also, the total pixels on your 3 props must equal the number of pixels assigned to that port. What is the distance from your controller to your first prop in that run?
392 pixels, and you injected once at the opposite end. It's possible that is not enough.
Here's how I would test: first, increase the pixel count assigned to the port to be more than what you're supposed to have. If they're not red anymore, you're got a port mismatch problem. But if they're still red (and especially intermittently red), then next try lowering the brightness. By a lot. If that fixes it, it's the power injection. Start by moving the injection point to the beginning of your bedroom window, instead of the end.
Sorry I should have added more detail. That is not my only PI run for this string of props. I'm actually running these of their own 12v 29A PSU at them moment so I have V- & DI going from the controller to the first pixel in my bay window. I'm injecting power at 1 and again at 160, so the beginning and the end of the bow window. Then I have another PI at the last pixel of my bedroom window which would be number 392 in the chain. I chose those PI spots after running it through the Spiker lights calculator.
Additionally I'm running the lights at 30% brightness which still leads me to believe that it's not a power issue. The first pixel is about 15 feet from the controller and I'm not having an issue until 9 pixels from the end of the chain. I do have F-Amps that I could use, bought them just in case, but wasn't sure that would even help since the 111 pixels before these red ones are receiving data with no issues.
I could move the PI to the beginning, but I thought rule of thumb was to always PI at the end no? At least I think that's what I got from Bill Porters presentation. But if it works it works!! hah
I think Bill Porter said to always start with PI. I don't think you can lower brightness much more below 30%, so PI might not be the problem. The nice thing about injecting at the end is that you can put in a different DC12V supply but still share the same power line; which actually goes against what he presented. You actually want the voltage drop in that situation.
We test our data lines in the lab all the time simply by sticking 50-pixel strings on the ports, even though the ports are configured for 500 pixels. Same principle: configure Xlights/FPP for 500, even though your hardware is only 392. If the last 9 are flashing now, then your data packets were too short.
