Hi,
I am adding a star to the top of my pixel tree. I have an e682 at the bottom of the tree and all outputs are used for the strips of the tree. I am wondering what the best way to connect the star is. Was thinking that I can just wire to the last string of the tree but not sure that is the best configuration. The 16 strips on the tree are 50 pixel 12v strips. Anyone have recommendations?
Thanks!
When I wired my Pixel tree, I only had 21 nodes on each string. So what I did was zig zag. In the drawing you can see I have a 12 string tree. But I only use 6 sockets. Each string is 42 nodes and I reverse every 21. So I just wired a connector between each two strings at the top of the tree. Due to the fact that you use a full 50 nodes per string, if you were to do the same as I did, and then also inject power at the bottom pf the second string... You would reduce your number of sockets to 8 by changing to 100 node strings reversing every 50. Then you'd have 8 sockets to expand for your star and other things.
What Jeff said...
I have a 24 string, 50 pixels per string mega tree, combined into 12 outputs from my E682 and mapped as 100-pixel strings within xLights. My E682 is also treating the strings as 100 pixels per string. Output #13 is for my 90 pixel star.
Oh, and unless you keep your brightness at 100%, you won't need to power inject. Use at least 2 power supplies and you'll be fine - I used 1 power supply for each "side" of my E682.
What firmware are you using with the E682?
How many pixels in the star?
Firmware is 4.081. The star is 90 pixels.

