Pixel dead... Quest...
 
Notifications
Clear all

Pixel dead... Question

6 Posts
2 Users
0 Reactions
1,927 Views
dsmjuggalo
Posts: 663
Topic starter
(@dsmjuggalo)
Prominent Member
Joined: 15 years ago
[#29200]

I finally had my first pixabulb failure today. For the last couple weeks the bulb has stayed lit even when not getting data. Well today it finally died on me. Problem is now the whole strand after it is out. I haven't had this happen before, usually the strand after a bad bulb stays on all white for me. It's up on my roof so that's why I'm asking about it here before climbing up there in the snow. Will just splicing in a new bulb take care of this? This would happen today since the local paper will be out tomorrow to take pictures lol.


5 Replies
dsmjuggalo
Posts: 663
Topic starter
(@dsmjuggalo)
Prominent Member
Joined: 15 years ago

Nevermind fixed.... Just swapped out bulbs


Reply
dmcole
Posts: 2196
(@dmcole)
Noble Member
Joined: 19 years ago
dsmjuggalo wrote:Nevermind fixed.... Just swapped out bulbs

Jug:

How did you "swap" out a bulb? Did you splice into the string or is there some magic way to change the interior of the PixaBulb I have yet to have figured out (the only way I got a PixaBulb open was to basically masticate it).

Thanks.

\dmc


Reply
dsmjuggalo
Posts: 663
Topic starter
(@dsmjuggalo)
Prominent Member
Joined: 15 years ago

I spliced a new one in place of the bad one.


Reply
dmcole
Posts: 2196
(@dmcole)
Noble Member
Joined: 19 years ago

Yeah, I found my open one and the wiring goes into the potting material, so a splice is the only way. I've got some problems I'm struggling to fix and was hoping for magic.

Thanks.

\dmc


Reply
Page 1 / 2
Share: