Pixel alignment mes...
 
Notifications
Clear all

Pixel alignment mesh-wire

11 Posts
7 Users
0 Reactions
4,921 Views
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago
[#26734]

I wish I had discovered this last year .

This will be my saving grace for properly aligned pixels .

My pixels will also have 1/2 strapping zip tied and taped to them for mounting and tension purposes.

The mesh is purely for alignment .


10 Replies
Posts: 207
(@onewish1)
Estimable Member
Joined: 14 years ago
Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Looks good, I'm assuming that it's 1/2" welded wire mesh.

Personally I think that the square flat pixels would work a little better since they don't hang out as far so less weight pulling down on the back.


Reply
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago
timon wrote:Looks good, I'm assuming that it's 1/2" welded wire mesh.

Personally I think that the square flat pixels would work a little better since they don't hang out as far so less weight pulling down on the back.

What if you don't like the looks of the Square pixels ?

I prefer the look of bullet style , imho they suit a mega tree.

The square pixels would suit being hidden behind a matrix . 🙂


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago
angus40 wrote:What if you don't like the looks of the Square pixels ?

I prefer the look of bullet style , imho they suit a mega tree.

The square pixels would suit being hidden behind a matrix . 🙂

IMHO, I don't really think you see any difference either during the day, unless you get really close, and at night there is no way you see any difference at all. Both of them use the same 8mm domed LED. The only difference is that one has a body that 3/4" square, about 3/8" thick and the wires com out the side. The other has a body that 1/2" round, 7/8" long and wires that come out the back. From an angle during the day I think you'll see the round ones with the wires sticking out more than the square with the wires close to the mounting band.


Reply
Page 1 / 3
Share: