I am new to pixel light control and have been trying to get up to speed. I have 1500 rgb pixels to control a pixel matrix and a pixel tree.
My matrix will be 30 rows of 34 pixels. 5 rows of 34 pixels ( 170 pixels) will make one string. So I will have 6 strings of 170 pixels.
I assume that each string of 170 pixels will plug into on of the jacks on the e682 board. Does that really leave me 10 more open inputs for more pixels or am I limited to a total number of pixels that can be controlled by the e682?
I am correct in this. 3 strings of 170 = 510 pixels which is one universe. So that with 6 strings I am using 2 universes and 4 still available?
One last question. Can I have Vixen control the 6 strings control the pixel matrix and use the other inputs to control other decorations?
Thanks
Covewi
Your math is wrong - Universes are in Channels not Pixels. 3 Strings of 170 pixels = 510 pixels 510 pixels * 3 Channels per pixel = 1530 Channels
So your 3 strings of 170 are actually taking up 3 universes on the E682 controller. You haven't said wether or not your doing multicast or unicast. The E682 can support 7 universes in multicast or 12 universes in unicast. So 1190 pixels (multicast) or 2040 pixels (unicast)
On any one output you can theoretically put about 500 pixels - However, refresh rate is affected by the number of pixels on an individual output. As you have indicated above you want to put 170 pixels on each output and that will not be a problem.... except you will need to power inject at some point depending on the voltage used. Basic rule of thumb every 50 pixels for 5 volt and every 128 pixels for 12 volt (YMMV)
So based on your plan above you would have 6 strings of 170 = 1020 pixels you would have room for 170 pixels (multicast) or another 1020 pixels (unicast) somewhere on the last 10 connectors.
Keep in mind that the outputs on the E682 are grouped in 4's so if you put 170 pixels on outputs 2-1, and 2-2 you would also need to put 170 on 2-3 and 2-4 if you want to use them.
The limits of the E682 is 12 Universes using Unicast. 510 channels per universe. 3 channels per pixel. So one universe is 170 pixels. Therefore, max pixels is 12x 170 = 2040 pixels.
How they get connected to your controller depends on the convenience in wiring and power injection. For strings of bullet nodes, 5v pixels need injection after 50, someone said 12v pixels need it after 88 pixels, but I don't have any personal experience with 12v other than strips.
What size pixel tree are you making. Most of your pixels will be in the matrix.
Yes you can use Vixen. Gets to be a lot of channels to sequence, but yes you can.
Thanks for all fast responses.
Skunberg - can i just use lights / nutcracker to run the matrix?
