How many ws2811 inp...
 
Notifications
Clear all

How many ws2811 inputs can I parallel?

25 Posts
9 Users
6 Reactions
3,348 Views
Posts: 2229
Topic starter
(@plasmadrive)
Famed Member
Joined: 15 years ago
[#58548]

I have 78 LED rings that go around the engineer's cabin on my locomotive. They are not going to be quiet as close together as the pic, but less than 1" apart. I was just thinking that I don't really need them all to be independent so I might want to drive them all as one set of pixels. If I do that, I will need to know how many I can drive with all inputs in parallel. I'm guessing not 78 of them.. So the next question is what is the drive capability of something like an F-amp?

Anyone have any real specific technical knowledge of drive capability of the ws2811 output and/or the F-amp drive capability?

ring lights

24 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Probably not too helpful, but I had a 17' pixel pole that used 6 pixel strips connected in parallel with a single ESPixelStick driving them. They worked great. I'm sorry I don't know the total fanout capability might be.


Reply
Posts: 2229
Topic starter
(@plasmadrive)
Famed Member
Joined: 15 years ago
dirknerkle wrote:
Probably not too helpful, but I had a 17' pixel pole that used 6 pixel strips connected in parallel with a single ESPixelStick driving them. They worked great. I'm sorry I don't know the total fanout capability might be.

Thanks.. I am sure I can do at least 8 but not sure above that.


Reply
critic2
Posts: 1389
(@critic2)
Noble Member
Joined: 17 years ago

I picked up some seed pixel trees from Lowes this year and ran each tree on one output each with a kulp F8PB.
There were 16 strings of 11 or 17 pixels in parallel (4’ or 6’ tree). The connection from the controller to the top of the tree ring was 15ft.
I didn’t see any issues albeit I was running static or slow fades.

IMG 0100 compressed

IMG 8499 compressed

Reply
Posts: 75
(@mark-m)
Trusted Member
Joined: 3 years ago
critic2 wrote:
I picked up some seed pixel trees from Lowes this year and ran each tree on one output each with a kulp F8PB.
There were 16 strings of 11 or 17 pixels in parallel (4’ or 6’ tree). The connection from the controller to the top of the tree ring was 15ft.
I didn’t see any issues albeit I was running static or slow fades.

IMG 0100 compressed

IMG 8499 compressed

Some of those seed pixel trees have a hard coded start address on the first pixel in each strand. Or there are some trees with all in parallel and no individual strand control.


Reply
Page 1 / 5
Share: