Hinkspix Pro WiFi s...
 
Notifications
Clear all

Hinkspix Pro WiFi setup help needed

7 Posts
4 Users
0 Reactions
6,549 Views
Posts: 2
Topic starter
(@tpthatsme)
New Member
Joined: 6 years ago
[#54213]

Hello friends, I am just getting started in the hobby and I feel like I am very experienced in home networks and such, but for the life of me, I cannot setup the Hinkspix Pro on my WiFi network. I can connect via Ethernet without a problem. I am looking for suggestions and opinions on if the controller is performing as expected (maybe it is bad?).
1. I am making sure that the WiFi network is 2.4Ghz.
2. I have tried to setup the HinksPix manually with SSID and password with and without DHCP.
3. I have tried to bind the MAC access of the Hinkspix wireless to my router with an IP.

Here is the easiest and less tech example of setup with failure.
1. Connect via Ethernet and delete the access point and IP addresses to start from scratch. Save and Reset.
2. Connect PC to Hinkspix WiFi and navigate to 192.168.4.1
3. Select a 2.4Ghz Access Point from the list and enter its password at the bottom.
4. Test the network. It is always successful.
5. Unplug Ethernet from Hinkspix and Reset.
6. Once Hinkspix is rebooted, the display shows IP 10.10.10.10. I check the WiFi settings on the Hinkspix and it shows a valid IP (192.168.1.36) and my network SSID.
7. Orange light blinks on/off 1000ms to indicate a successful connection to the internet (this is my understanding).
8. Navigating to 192.168.1.36 on the same SSID times out.
9. My router shows no connection to 192.168.1.36.

details

Am I missing an obvious step? Any suggestions on what to try next?


6 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

What is your planned usage of wifi on the HinksPix ? I never found a real benefit to it .


Reply
Posts: 2
Topic starter
(@tpthatsme)
New Member
Joined: 6 years ago
angus40 wrote:What is your planned usage of wifi on the HinksPix ? I never found a real benefit to it .

My expectation was to connect xlights to the controller via WiFi so that I can run my show or make changes via WiFi. Your question make it sound like this might not be possible. After looking again at xlights, I see that there isn't an option for WiFi. So are there only 2 real options? SD Card show or connected to your network via Ethernet?


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Yes SD and ethernet is what I have known to be premium with this controller. The SD I believe was initially for standalone usage . With the number of universes the HinksPix is capable of WiFi would be unstable .
I have not tested to verify but FPP may be an excellent choice for the HinksPix .

I have always setup the hinks controller via ethernet and set a static IP.
Using this method wireless connecting has never been an issue.


Reply
Posts: 2
(@mrmark)
New Member
Joined: 6 years ago

...


Reply
Page 1 / 2
Share: