help setting up in ...
 
Notifications
Clear all

help setting up in XLights

9 Posts
4 Users
0 Reactions
6,492 Views
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago
[#46637]

Hi again All....still plugging away at my first mega tree set up. I am using 2 Alphapix 16 controllers to run a mega tree with 24 strings of 50 nodes on each string. I know there are numerous ways to do this but I went with using one string per output. I have been getting help with setting up the controller and getting to the point that I need to get it all set up in xlights, but cannot figure it out from here.

I am attaching sheet that has how I have the controller set up.

If you could check it out and possibly help I would appreciate it...
Here are my questions: For my Controller #1 do I put the number of Universess at 16 per controller or 12? (I am only using SPI #'s 1-6 & 9-14 on each controller (per the set up configuration)

Also...For the 2nd controller do I put the start universe at 1 or 13? Again should the # of universes be 12 or 16 (only using SPI #'s 1-6 & 9-14 on this controller too)

my head is beginning to spin and I am just confusing myself more

controller set up
xlight1
xlight2

8 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

why are you using 2 alpha 16 for 24 string tree?


Reply
LightUpMA
Posts: 208
(@lightupma)
Estimable Member
Joined: 15 years ago

Well I don't know that controller well but start with this. Each pixel is 3 channels (red, green and blue) So your first line is right but 50 pixels uses up 150 channels. Next line - output 2 same universe 1 but start channel 151. Third line universe one start channel 301.

For the fourth output I'd start over with universe two and use 3 lines / 3 outputs of 50 for each universe. Unless that controller allows you to start at channel 451. You only get 170 pixels per universe so the string would go between 2 universes.

The lines and outputs you aren't using should NOT duplicate channel numbers. If you can'tleave blank then use universe 99 and start channel 1 (3 channels for the one pixel). Next fake one starts on channel 4. But you should be able to skip or not use at all.

Xlights has to match universe and channel numbers.


Reply
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago
TazChaLet wrote:why are you using 2 alpha 16 for 24 string tree?

It is just what I bought and am trying to make it easiest on myself but I am just getting confused.

Sent from my iPhone using Tapatalk


Reply
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago

I am open to any way to make it easier to set up and understand.
Again, this is my first year with this and it has taken me a while just to get to this point.
Thanks again for any suggestions and help.

Sent from my iPhone using Tapatalk


Reply
Page 1 / 2
Share: