After looking at it closer. It has a beaglebone attached to it. Have you checked out Dan Kulp’s controllers at Kulplights.com?
Sent from my iPhone using Tapatalk
TSL wrote:After looking at it closer. It has a beaglebone attached to it. Have you checked out Dan Kulp’s controllers at Kulplights.com?Sent from my iPhone using Tapatalk
No I haven’t I’ll check but it’ll probably just confuse me more lol
Sent from my iPhone using Tapatalk
Dan is one of the FPP people. I’m sure he’ll answer any questions you may have about his stuff.
Sent from my iPhone using Tapatalk
TSL wrote:Dan is one of the FPP people. I’m sure he’ll answer any questions you may have about his stuff.Sent from my iPhone using Tapatalk
Thanks
Sent from my iPhone using Tapatalk
Johnfish211 wrote:My show at present has 4 sandevices 2 e682 and 2 6804. I want to add another controller this year and I am not sure which direction to go. I have it narrowed down to a 16 port falcon or the Kulp 32b or another e682. The 32 b is very attractive at 95 dollars. I have found no comparison between the falcon and the Kulp so I am having a hard time deciding. The e682 is a robust but older tech controller but I know it well.Any thoughts?
Switching to Falcons from E682 2/3rds through my first year saved my year. The design is well thought out, well supported, well documented, used by many peers, and robust at the software and hardware level. The web interface is much easier to use and there are a lot of convenient features. The length of wire runs I could do without flicker problems increased by a lot. I can’t compare specs / experience for you, but I can say I wouldn’t think twice about trying something else at this point. I have two F16v2s and one F16v3.
The only issue I have had since 2016 is bugs in the F16v3 test mode. I bought that controller in November, it was just released in 2019 so that will likely be fixed. Plus future firmware releases will enable several new features already planned for in the hardware design (eg Wi-Fi)
Sent from my iPhone using Tapatalk
