Notifications
Clear all

E682 Problem

7 Posts
4 Users
0 Reactions
2,190 Views
Xenia
Posts: 1358
Topic starter
(@xenia)
Noble Member
Joined: 15 years ago
[#30266]

Went to play with my spare E682 and i cannot get the web server to come up. All three yellow lights are on and after a moment the red and green come on and stay solid, green does not ever flash. It worked when i put it away last spring and i have the IP address label on the board. Any quick suggestions before I start over with this board?


6 Replies
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Set you pc ehternet adapto to DHCP, disable your wireless and go straight to your controller, reboot your pc and controller, then do a command prompt after everything is up ipconfig /all and see what you addressing kicks back. Might give you a clue as to the IP range of your board.


Reply
Xenia
Posts: 1358
Topic starter
(@xenia)
Noble Member
Joined: 15 years ago

Board is hardwired to a switch, PC is 192.168.2.140 switch is 192.168.2.4 and E682 should be 192.168.2.25. No problem pinging the switch but nothing to the E682.. All of my E68X and my RPM Bridge are on my 192.168.2.xxx network. Also i had the RPM hooked up to the switch on the same CAT5 and it worked as expected.

My concern is that the green light never flashed and I thought it was supposed to flash twice on boot-up for static IP? I guess it is time to break out the laptop and see if I can figure out the problem.

LED Activity during Startup
During startup, after a few seconds of delay, the left green LED will flash one or more times
to indicate the current network configuration:
1 flash = Current saved IP MODE is DHCP, and an IP address was obtained from a DHCP server.
2 flashes = Current saved IP MODE is Static, and the last STATIC IP address saved in memory
page 0 was used. Default IP is 192.168.1.206
3 flashes = IP address was obtained from DHCP, because it was forced by the pushbutton.


Reply
Xenia
Posts: 1358
Topic starter
(@xenia)
Noble Member
Joined: 15 years ago

Ok, still no luck. Tried forcing 169.254.x.x, computer booted up to 169.254.62.65 and 169.254.74.73 did not work. I also manually set the PC to 192.168.1.10 and then tried to connect to 192.168.1.206 but no luck.

Ok, just by dumb luck, I held down the prog. button and while holding it down pressed and released the reset button. I then waited for the green led to flash once and released the prog. button. Finally the red and green buttons start flashing and I relaized after a minute that if you use green flash as a "dot', the wiznet was "spelling" out it's ip address so you had one gree followed by 1 red followed byt one greene flowllowed by nine reds followed by one green followed by 2 reds and so until it spelled out 192.168.1.25 instead if 192.168.2.25 as I expected it to be. Ip corrected, hooked back to switch and works fine now.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Thanks for the update, will have to watch for that if I forget one of my IP's.


Reply
Page 1 / 2
Share: