I just built an E682 and got to the part of the instructions for testing the power and one of the LED's is not lighting. The LED that is not lighting is the 3.3v. I emailed and was told the following. My results are next to his response.
You should have +12V on power jumper pins 3 and 4. RESULT: 3.5v
You should have +5V on power jumper pins 1 and 2. RESULT: 0v
You should have +5V on the upper pin of the voltage regulator. RESULT: 0v
You should have +3.3V on the lower pin of the voltage regulator. RESULT:0v
I am using the Holiday Coro Rain Proof Power Supply - 12v / 33 amps / 400 Watts to supply the power. I have the power jumpers on the board set to 1,2 and 3,4
I am not an electrical expert at all, so I am at a loss as to what to do next. I have double and triple checked all solder joints for cold solder and bridges, and did not see any just in case that was the issue.
Any suggestions on what could be the issue?
Any help is greatly appreciated.
Kyle
Take a picture of the front and back of the board... As clear as you can.
Sent from my SAMSUNG-SM-G890A using Tapatalk
Everything looks correct... What leds are lighting? Are the 8 resistors seated good ? Your jumpers look correct... The only thing I can't see is your capacitors, double check those...The two upper right ones play an important role.... Lastly, make sure some of the solder joints have enough solder. I've made a few board and I had portables with not enough, basically looked connected, but wasn't. Let's see if someone else chimes in...
Sent from my SAMSUNG-SM-G890A using Tapatalk
Hook.up your power supply to... J18... Then using your volt meter, negative lead on negative terminal at J18... Check your voltage at the jumper pins in upper right. 1-2=5v...3-4=12v...
Sent from my SAMSUNG-SM-G890A using Tapatalk


