Good afternoon,
I have an e681 upgraded by Jim that’s run 5v pixels for 6 yrs. A couple mice got into the pixels and I decided to replace them with 12v. So I bought a 30amp 12v ps and changed the jumpers to A and C.
The unit ran fine at 5v last week. Now at 12v with jumpers in proper locations the two yellow pixel lights at lower corners come on but no other lights. I tested the power supply and it’s putting out 12v.
When I test the top of voltage regulator I get 1.5v and bottom give .7v. I assume this part needs replacing. I have some L1117 3.3v regulator that would fit but according to what I read they output 800ma not 500ma.
1. Should I replace this part or check something else?
2. If replace this part can I use L1117 or go purchase a LF33cv?
If anyone has any thoughts I would appreciate it.
Thanks,
Wayne
I know you tested for 12v but some of the 681’s were very finicky on voltages. Try turning it down to 11.25V first. I have a 682 that goes nuts with anything over 11.5v.
Just something I would try that doesn’t cost anything but some time....[emoji846]
Sent from my iPhone using Tapatalk
And if you just bought your 12v pixels, they changed the timing on the chip and your 681's firmware will not support the newer pixels, Jchuchla went through similar issues getting newer pixels to work on a 681
