I am using Madrix to talk to an E681. Below is my E681 set up and my Madrix set up. Basically I am looking to control 4 differnt pixel set ups on the 4 Universes. The reason is to show a pixel controller driving different pixels in a practical implementation at our CLAP meeting. The other reason is to show our attendees what the ramps look like in a side by side comparizon of the different 5-12bit pixels.
U1 = 2801 pixel Strip - U2= 6803 square pixel - U3= 2801 square Pixel - U4 = 3001 square pixel. I am only trying to drive 2 strings each of 50ct pixels, and the Strip is 160 pixels.
,
I am only using the first or second plug per section, so 1-1, 2-1&2, 3-1&2, 4-1&2
In testing the E681, all universes/pixels test fine plugged into the above slots.
When I drive the E681 via Madrix, U4 with the 3001's do not light at all. I think I read a post a while back about this but can't remember which forum and a search here turned up nothing.
I am not sure what could be causing this. Any ideas? Thanks.
It's the web server - it uses Socket #4 of the Wiz module and keeps data from being processed for the pixels. It will work fine if you don't update the web GUI after 5 minutes - or - just do "QUIT 10" and it will exit after 10 seconds. Look at the red LED near the top of the board - it indicates web server access.
You can configure the E68x to not bring up the server - review the manual on details. Also - you should play with the Gamma correction if you are showing off dimming. I found a value of 1.9 worked pretty well.
Brian,
That was it. It is now working. Thanks!
Please excuse the ignorance of this next question. I know one advantage of the 3001's is the gamma correction. In simple terms, what does this do for us?
zman wrote:Brian,That was it. It is now working. Thanks!
Please excuse the ignorance of this next question. I know one advantage of the 3001's is the gamma correction. In simple terms, what does this do for us?
Well - Jim would be able to provide a better answer I'm sure but basically since the 3001's have 12-bit level dimming and the data coming in is 8-bit, it can shift around the curve so that you get a more linear light response. Really you want 10% to represent 10%, 50% to represent 50%, etc - but in reality the LEDs are non-linear so 10% from Vixen could actually put out 40% of the light (for example) and as you go up in the higher levels (say above the 8-bit level of 200 of 255), there may be very little change in the light level.
You can see this very clearly with your setup - use it at gamma level '1' and ramp up and down bit by bit - do it again at '2' and you will see a big difference. You will get much smoother ramps/fades by playing with this level. Around 2.0 give or take is a good place to start.
Thanks Brian, I tweaked it to 1.9 as you mentioned, and there was a very noticable difference in the ramp.


