Hi all
I bought an E680 recently and have finished assembling except I had 3 components left over.
One is a green thing that looks like a resistor, I cannot for the life of me read the writing on it. Am I correct that this would be the pigtail fuse?
Secondly I had a blocking/power diode? I dont see one of those on the assembly list
And finally I have a .1uF capacitor left. Thee assembly instructions on the E680 website list 3 of these and the one that it shows going next to the small 2 block connector, I cannot place on the board because there is only 1 component hole there not 2.
Is anyone familiar with these could help me please?
Steve
Was this bought through the group buy? I'm not sure what type of fuse Mark supplied so I can't say for sure on that one.
The diode mounts inside of the CPU socket toward the top end, on the silkscreen it's marked as a 1N4002. This was a recent addition to the board and may not be reflected in the documentation that you have. Banded end toward the top of the board.
There are 4 .1uf caps on the E680.
One mounts to the left of the 3.3v regulator, one inside the CPU socket, one just to the right of the CPU socket by the crystal, and one just to thr right of the 6-pin header. In each case the silkscreened legend is a rectangle that encloses the 2 mounting holes, with ".1uf" printed inside the rectangle.
Hi
Thanks for the reply. Yes this was purchased through the group buy.
I used the assembly manual at www.sandevices.com/documents/e680_assemman.pdf to assemble it.
Is there an update to this?
Sorry, you are correct, there were 4 of the caps and on the assembly manual I followed it has 1 between the capacitor and the 2 block terminal connector/
So you are saying one of them should go in the cpu holder itself? because I never used the socket as it got damaged so I soldered the chip directly. Am I still able to position the cap now? and consequently the diode.
there was no other component so I would have to assume the green component is the fuse and install it as such.
If you didn't use the CPU socket.... You would have to solder to the points under the board. Be careful when soldering directly to the CPU... it is very heat sensitive
Attached is layout of the PCB. From this you should be able to determine which pads to solder the diode and cap to. Just solder them from the back side of the pc board.

