So I am getting ready to test my display and have my setup like this.
Pc to switch switch to e680 and switch to diyledexpress bridge.
The problem is that I can not connect to the e680 webpage through the switch. If I disconnect the cat5 from the switch and directly connect it to the computer I can but when the switch is there its a no go.
The bridge on the other hand I can connect to the webpage through the switch just fine.
E680 has version 4.033 on it and upgraded wiznet. The switch is a cheap dlink switch running its own power supply that came with it.
Heres the switch I am using. At least I think it is. Where I got mine they no longer list it on their website. I will
http://www.frys.com/product/6288820
Any pointers or suggestions?
Travis
There has been previous discussion on some of the boards about problems using a gigabit switch with the 10/100 Wiznet modules. Even the upgraded Ethernet module is still 10/100.
I happen to be running a Netgear Gigabit 5 port switch and have not yet encountered a problem with my E680's, but it always stays in the back of my mind that I might.
Thats what I have found out too. Maybe it is an issue with mine. I will find one in the next couple of days to test out.
Travis
same issue here, doesnt like gig switchs
Actually mine is not a gigabit model I linked to the wrong one. Here is the one I have.
http://www.amazon.com/D-Link-5-Port-Unmanaged-Desktop-DES-1005E/dp/B003WOWB5S
Mine is the 1005d but looks like the e. Man I should have kept the box and manual so I know for sure.
Travis
