E1.31 controller po...
 
Notifications
Clear all

E1.31 controller power source + data singal distance limitations.

12 Posts
6 Users
0 Reactions
2,852 Views
Posts: 11
Topic starter
(@abhijitz)
Active Member
Joined: 11 years ago
[#43153]

Hi All,

I am planning to use an E1.31 controller to control several light strips. 4 windows & a garage outline. Each window can be covered by 1 16-ft, while the garage will need 3.

As i see from the available E1.31 controllers in the market, like the F16V2-R or the Aplha 16 controller form HolidayCoro, I could comfortably run 1 string off each output (Two maybe tighter, with only 340 pixel / output) BUT, for my garage line can i use the other outputs to just carry the power injection line separately? What is the maximum length this power injection line will support off the output.

To break the question further, let say i use outputs #1-#4 for 4 RGB strips and strategically place them so i am within 30ft of the controller, but my garage setup will be almost 70ft away from the controller. So, if i run 3 RGB strips ... what is the max length of power injection lines and the data/clk lines. I also read that in order to repeat the data/clk signals i would need to insert a null pixel?

Thanks!


11 Replies
Posts: 317
(@spyder)
Reputable Member
Joined: 11 years ago

Another psu in the garage would solve you 1 problem just leaving you to to add nulls if required.

If you use spare outputs for power injection just remember to bear in mind the added load.


Reply
Posts: 11
Topic starter
(@abhijitz)
Active Member
Joined: 11 years ago

Thanks. Would you know a ballpark figure at what distance intervals a null would be required for data signal regeneration?

Spyder wrote:Another psu in the garage would solve you 1 problem just leaving you to to add nulls if required.

If you use spare outputs for power injection just remember to bear in mind the added load.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Keep in mind that if you use the power from spare outputs for injection that your distance is likely the same or greater than the original power source also coming from the same place. So your voltage drop will likely be the same (given the same wire size). The idea of power injection is to provide new clean power in your chain of pixels. So injecting power that's just as degraded as what's already there wouldn't offer much benefit.

Sent from my iPhone using Tapatalk


Reply
Posts: 11
Topic starter
(@abhijitz)
Active Member
Joined: 11 years ago

Thanks, this perfectly makes sense. How do i calculate the distance limitation for signal then? For example, my controller will be almost 70ft away from the garage ... At what position do i introduce a null to carry it forward (just not getting the match).

jchuchla wrote:Keep in mind that if you use the power from spare outputs for injection that your distance is likely the same or greater than the original power source also coming from the same place. So your voltage drop will likely be the same (given the same wire size). The idea of power injection is to provide new clean power in your chain of pixels. So injecting power that's just as degraded as what's already there wouldn't offer much benefit.

Sent from my iPhone using Tapatalk


Reply
Page 1 / 3
Share: