Notifications
Clear all

Can I?

6 Posts
4 Users
0 Reactions
1,998 Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
[#48596]

Right now I'm using a 682 for a pixel tree utilizing all 16 outputs. I'm running 2-12 volt 350 watt power supplies. 16 strands of 55 pixel each. I'm curious if I can get away with 1 power supply if I'm running the pixels at 25%? These are square pixels and I think the wattage if each is .6 watts.

Sent from my SM-T710 using Tapatalk


5 Replies
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

Everything I have seen is that the power consumption of pixels is in direct proportion to the "Brightness" level you are running, so at 25% you should be able to run close to 4X the pixels on the same power needed @ 100%.


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
TomL8345 wrote:Everything I have seen is that the power consumption of pixels is in direct proportion to the "Brightness" level you are running, so at 25% you should be able to run close to 4X the pixels on the same power needed @ 100%.

I kinda thought the same thing. Thank you.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

I don't think it will be an exact ratio like that. I remember testing current draw on my 270 pixel star and even with the pixels off it was pulling 1 amp so you will have a base current draw regardless of the power setting.


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

I ran 100% with an e682 with a 16 x 50 tree on one power supply until this year. I changed to 50% because I could with the new e682 software. I never seemed to have any issues but I didn't run full white very often. The only reason I did it was because I saw David Pitts doing it (one power supply on a 16x50) at a Christmas Expo near Dallas a few years back. I also ran both square and bullet pixels the same way.


Reply
Page 1 / 2
Share: