Bullet vs Square Pi...
 
Notifications
Clear all

Bullet vs Square Pixels

27 Posts
12 Users
0 Reactions
8,964 Views
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago
rstehle wrote:I have never had a fire, and very few failures with Ray's pixels. Never an out of the box failure.

Ray has been our go-to for any bulk buys of pixels. Still is!


Reply
Posts: 186
(@steve123)
Estimable Member
Joined: 7 years ago

About 20% of the xConnect extensions and pigtails I received from Ray were malformed. It appeared to me the ends of the male connectors had been crushed. I was able to make them work but there was a lot of persuasion required to get some of them to mate.

Same thing with the end caps. Quite a few of the female end caps (the cap is a male) had the plastic pins inside skewed in odd positions.

I purchased 5V square pixels. There is poor consistency in the shape of the pixels. Some are square, many are deformed and are more rectangular than square. The lens is quite often skewed and not perpendicular to the base of the LED. Wire entry and exit is not uniform.


Reply
Posts: 2
(@paradigm)
New Member
Joined: 8 years ago
algerdes wrote:All things considered, I hope that Ray is watching. He has done well by us in the past. Perhaps this will trigger an upgrade in his product.

I think he must be. After I posted my issue I had with my square nodes here, he contacted me and expressed it bad batch of epoxy and offered to fix the situation. I really didn't expect that. First time I have ever had an oversee vendor admit to a quality error and offer to fix it without me asking for anything.


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago
paradigm wrote:I think he must be. After I posted my issue I had with my square nodes here, he contacted me and expressed it bad batch of epoxy and offered to fix the situation. I really didn't expect that. First time I have ever had an oversee vendor admit to a quality error and offer to fix it without me asking for anything.

Way to go Ray!


Reply
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 19 years ago
JerryPlak wrote:I haven't done a video yet

Sent from my SM-G970U using Tapatalk

Jerry, You always amaze me!

Jeff


Reply
Page 5 / 6
Share: