Bullet vs Square Pi...
 
Notifications
Clear all

Bullet vs Square Pixels

27 Posts
12 Users
0 Reactions
8,966 Views
Posts: 246
(@jerryplak)
Reputable Member
Joined: 19 years ago
TSL wrote:Nice tree. Do you have a video of it in action?

Sent from my iPhone using Tapatalk

I haven't done a video yet

Sent from my SM-G970U using Tapatalk


Reply
Posts: 186
(@steve123)
Estimable Member
Joined: 7 years ago
JerryPlak wrote:For this project I used both types of pixels

That's a very cool tree. Did you weld that together yourself? Looks like 3 types of pixels, bullet, square with diffuser and C7?


Reply
Posts: 186
(@steve123)
Estimable Member
Joined: 7 years ago

Anecdotally, 12V squares appear to have a higher failure rate and pixel fires. Not sure if anyone has collected any statistics to back this up though. I use 5V squares and bullets.


Reply
Posts: 246
(@jerryplak)
Reputable Member
Joined: 19 years ago
steve123 wrote:That's a very cool tree. Did you weld that together yourself? Looks like 3 types of pixels, bullet, square with diffuser and C7?

I had these wire frames trees for years I got they from Christmas done bright

Yes there's bullet, square pixels i did 3D printed pixels covers

Sent from my SM-G970U using Tapatalk


Reply
Posts: 2
(@paradigm)
New Member
Joined: 8 years ago

Just to chime in with my learning from failure. I had the same question last year and went with square nodes for my house outlines. Last year 12/1 - 12/30 I had no issues. However this year, after our first rain, I am having to replace all strings that had square nodes. The issue I am having is that the epoxy backing is all cracked. When it rained the boards got wet and now they just dont function as I think condensation is trapped inside. There is probably a small chance that once they dry out it will get better, however now even if there is moisture in the air they just blink random and don't pass the signal right.

One other thing I noticed was that my square nodes change color when the voltage is not quite strong enough, however my bullets just diminish in brightness. I am able to push 500-600 bullets at 20-30% brightness pretty easy. However my square nodes only make about 200 before they turn red.

All my bullet nodes are Paul Zhang and all my square nodes are Ray Wu. They were all ordered direct from each vendor. So perhaps it is quality or I just got a bad batch. I'm not too thrilled replaced my entire house outline the second week of December though.

Personally I think bullet nodes have a much smaller port that is filled with epoxy and it is filled deeper, thus is better protected where the square node is pretty exposed and as you can see from my picture, apparently crack.

Pixels 20201211 203109041

Reply
Page 3 / 6
Share: