Notifications
Clear all

Bad pixel?

11 Posts
6 Users
0 Reactions
2,709 Views
Posts: 100
Topic starter
(@gymgeek)
Estimable Member
Joined: 13 years ago
[#43769]

This is my first year for pixels and I've ran into a problem that confuses me a little bit. I'd appreciate any help from you guys!

I'm using Brilliant Bulbs for my house outline. I have a run of 68 pixels where nothing from pixel #51 thru #68 is working (never has). Since the problem starts where I added onto a string of 50, I assumed I messed up that joint somehow.

Today, I finally had a chance to look at it but everything looked fine. I'm using solder sleeves, so I reheated them to get the solder to flow but it made no difference. So, I cut off the heatshrink sleeve and the wires had a very good connection. My first thought was pixel #51 was dead. So, I connected another string temporarily, but it behaves the same way (does nothing). I checked the voltage at the end of the new string and I'm getting 11.6V, so it doesn't appear to be a power problem.

This leads me to believe pixel #50 isn't outputting a signal so all the other pixels down the line don't do anything. Is there a way to test that before cutting out pixel #50? Is there something else I should try?


10 Replies
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago

What are you using for your controller? It's possible your controller is set to only output pixels #1 to #50.


Reply
Posts: 100
Topic starter
(@gymgeek)
Estimable Member
Joined: 13 years ago

Good point! I'm using a F4V2 and pixel count is set to 68 though.


Reply
Posts: 138
(@chris2879)
Reputable Member
Joined: 19 years ago

Is the direction of the data correct between pixel 50 and 51?


Reply
Posts: 100
Topic starter
(@gymgeek)
Estimable Member
Joined: 13 years ago

Yes, I verified the direction using the diagrams on the holiday coro site. Thanks for the suggestion!

Sent from my SAMSUNG-SM-G890A using Tapatalk


Reply
Page 1 / 3
Share: