I have a project that's going to require 2 40ft pixel runs. I'm a complete newbie to pixels and while I've read up a bit on them I still have no idea what all I'll really need. I know with longer runs you'll have to inject power at different intervals and such.
What stings would you recommend? I had looked at the following strings: http://www.aliexpress.com/store/product/5m-WS2811-LED-digital-strip-60leds-m-with-30pcs-WS2811-built-in-the-5050-smd-rgb/701799_653641294.html but I'm not sure about voltage drop and such with a 40 foot run.
Likewise, what would be the best controller to use in this situation? What kind of wire would I be looking at?
Pixels are so much more complicated to me than the old systems where you just ran cat5 to relays.
do 12volt with a e68x series or a j1sys. you can do more pixels with 12v and longer runs. so depends on how many pixels your wanting to do per run.
Your link is to a 30 pixel/meter strip. You would need almost 2 1/2 of the 5 M strips to cover 40', for a total of around 360 pixels.
You would need to dividing that into at least two universes (per 40' strip), and to inject more power in several places.
If you meant to link to a pixel string (with wires between pixels), then you can simplify it all by using 12v pixels. With 4" spacing, you can cover 40 feet with 120 pixels and a single universe; RJ gets up to 128 pixels in a string powered from one end at 12V.
For example see http://www.aliexpress.com/store/product/128-node-LED-pixel-string-DC12V-input-new-model-IP68-TM1804IC/701799_495658226.html
In the setup I'm planning, the strip/tape pixels would work out considerably better than a string. Is there a 12V equivalent of that strip I linked?
You might have to email Ray and ask if it is available in 12v.
I have ask for items in 12v that were only listed in 5v and he had them in stock.
Scott
