I have a Kulp k8 pi and would like to add additional controllers. Do I just daisy chain the off the kulp k8 pi with ethernet cables?
The controller has expansion pins and i don't know it i can hook something to them?
Also are smart receivers a good choice for expansion? Does the one raspberry pi run the whole show?
Cant help with the Kulp question, but it is well accepted that a Raspberry PI 1 can drive over 1 million pixels.
Differential Receiver are great. From manual; If you do not send any serial data then you will have all the RJ45 ports available to connect Differential Receivers. Each RJ45 port can connect to one Differential Receiver or up to 3 daisy chained Smart Differential Receivers with an Ethernet cable up to 250 feet to the furthest Receiver. The Differential Receivers and Smart Differential Receivers each have 4 ports for pixel string connections.
There are different Differential Receivers. Verify before purchasing that they will work with your board.
Yes, your K8-Pi would be able to run a lot more. I have a K8-PB running 8 port, Different Receivers and a DMX (2 ports)
Other controllers can be added, if you add other Kulps (or any pi of Beaglbone Capes) they can be added as remotes and your current one would be a master. They sync data either wirelessly or via Ethernet depending on how you decide to set them up. You can also add pretty much any other controller like Falcon, Genius, etc and have the Pi send the data to them via wired ethernet connection. For Differential Receivers they would just plug into your K8-Pi. They are great to get data further away from your main controller.
